General Instructions - JANE Montecarlo R1 Instrucciones

ENGLISH
Your new MONTECARLO R1 from JANÉ is a seat designed to protect
your child in the car from approximately 3 years of age (15 kg in weight)
to approximately 12 years of age (36 kg in weight).
MONTECARLO R1 has passed the stringent safety tests of the European
Directive ECE 44/4 for groups 2 and 3.
To improve your child's safety, the MONTECARLO R1 seat is fitted with:
-A system that fastens to the car seat based on ISOFIX anchorings.
This fastening only serves to anchor the seat to the car, the child
must be held in with the three-point safety belt of your car.
-A headrest with 6 height positions to maintain protection as the child
grows.
-Higher sides provide greater protection against side impact.
-Impact-absorbent material on the sides and centre of the headrest.
-A headrest reinforced against twisting.
To improve the comfort and its adaptability to your child, your
MONTECARLO R1 seat has the following options:
-The width of the backrest and headrest can be regulated
independently.
-The seat can be reclined as it has 2 positions.
14
C M Y CM MY CY CMY
-The height of the armrests on the booster can be regulated.
-The chassis has a ventilation system.
-Extra padding.

GENERAL INSTRUCTIONS

In order to protect your child adequately and make sure
that they are comfortable and secure inside the car, you
must follow these instructions:
Your MONTECARLO R1 seat has been designed to be installed on
rear or front seats of a car, providing that you have three-point
safety belts and that the front AIR BAG is not connected. Even
so, we recommend that as far as possible, you install it on the
rear seat, as this will ensure maximum safety.
It is only valid for cars fitted with automatic, three-point
anchoring safety belts, approved in accordance with ECE-16 standard
or other equivalent standards.
DO NOT use with a two-point anchoring safety belt. This is very
dangerous should you brake suddenly or in the event of an accident.
K