Midea MDRB470MG Serie Manual De Usuario página 11

5. Change the refrigerator door:
1) Remove the cover plate of the upper end cover of the refrigeration door and the left decorative cover. Install the
upper shaft sleeve and the signal line of the door body to the other side and cover the upper end cover plate.
Take out the right decorative cover from the accessory bag and install it to the other side of the upper end
cover.
2) Remove the door self-locking, door stop and shaft sleeve of the refrigeration door, take out the left door
self-locking from the accessory bag, install it on the left side of the lower end cover of the refrigeration door,
change the door stop and shaft sleeve to the left side of the lower end cover of the refrigeration door.
6. Change the freezing door:
1) Remove the shaft sleeve and cap of the upper end cover of the freezing door and install them at the left and
right swap positions.
2) Remove the door self-locking, door stop and shaft sleeve of the freezing door, take out the left door self-locking
from the accessory bag, install it on the left side of the lower end cover of the freezing door, change the door
stop and shaft sleeve to the left side of the lower end cover of the freezing door.
7. Install the replaced freezing door on the lower hinge, then install the middle hinge and cover the hinge hole
decorative cover.
middle hinge
EN-9
decorative cover
EN