Installation - Electrolux ERTG203YSK Manual De Instrucciones

33 electrolux installation

Installation

Choosing the location
In order to ensure that heat dissipates
rapidly and that the refrigerator
operates efficiently, with low energy
consumption, we recommend leaving
the following minimum distances
between the refrigerator and the walls
and ceiling:
Top: 30cm
Sides: 20cm
Door side: 30cm
Back: 10cm
Check to be sure that there is enough
space in front of the refrigerator to
open the door (160°).
Install the refrigerator in a well-
ventilated area, away from direct
sunlight and from heat sources, such
as ovens and burners, from
inflammable materials, and from areas
where water is frequently used, such
as sinks.
Do not install the refrigerator
outdoors.
Leveling the refrigerator
Install the refrigerator on a completely
level and solid surface. The door must
be closed when leveling the
refrigerator
Use a level with glass-enclosed
bubble to verify whether the
refrigerator is properly leveled, with
the four feet firmly on the floor.
If the refrigerator needs to be
adjusted, carefully lean it and turn the
front adjustable leveling feet until it is
All manuals and user guides at all-guides.com
30cm
(top)
10cm
(back)
20cm
(sides)
30cm
(Door side)
firmly installed.
Proper leveling prevents movement,
vibration and other problems.
Do not substitute the original
refrigerator feet.
Wait at least 2 hours before plugging
the refrigerator in this will prevent
operating problems.
Electrical installation
Before turning on the refrigerator,
check to see if the voltage of the
outlet to be used is the same as that
indicated on the tag located close to
the plug (along the power cord) or on
the refrigerator's identification label.
Check to see that the refrigerator's
plug is not connected on top of the
power cord.
Connect the refrigerator to its own
outlet. Do not use an extension cord
or adaptor plug.
For your safety, ask an electrician to
verify the condition of the electric
wiring in the area where the
refrigerator will be installed.
The wires leading to the outlet into
which the refrigerator will be plugged
should be made of copper and be at
least 2.5 mm2 wide. For greater
safety, consult the legislation on
electrical installations in your country.
installation electrolux 34