Electrolux ERTG203YSK Manual De Instrucciones página 23

43 electrolux care & cleaning
Door seals
The rubber door seals should be
carefully cleaned with a damp cloth.
Rinse and dry them carefully to avoid
damage.
Substituting the light
Before changing the light, first unplug
the refrigerator, otherwise you may
receive an electric shock or be injured.
01.Remove the screws using a Phillips
screwdriver.
02. Remove the lamp cover by gently
turning it downwards.
03. Unscrew the lamp.
04.Place a new 10 W refrigerator bulb
of the same type and size.
05.Replace light cover and screws.
Cleaning the water tray
The water tray is located in the rear
part of the Refrigerator. Its function is
to collect the water that appears
because of defrosting and allow it to
evaporate. Normally, it does not
require special care; however, in the
event of overflow or unpleasant odors,
it should be checked and cleaned.
First, unplug the refrigerator. Lift the
tray slightly and lean it a little, carefully
removing the water. (Caution: make
sure that the drainage tube is not too
hot). After the tray is clean, replace it
in its original position. Make sure that
the tube is placed over the tray before
reinserting it. The tray should be
cleaned at least once a year.
All manuals and user guides at all-guides.com
After cleaning the refrigerator, check
the following:
01. Check to be sure the cord is not
damaged.
02. Check to see if the plug is
properly connected to the outlet.
03. Check to see if the grounding
cable is installed.
04. Check to see if the drain is
clogged.
Handle Fixation
One hand holds the handle firmly and
the other hand inserts the spanner into
the screw and screw up following the
direction of the arrow in the image.
Use the same method to screw up the
lower screw and fix the handle onto the
door.
care & cleaning electrolux 44
Llave