Specifications - IMG STAGELINE TXS-611SET Manual De Instrucciones

b Are the batteries of the microphone dis-
charged?
c Has the microphone been set to a low
transmission power? (
d Is the distance between the microphone
and the receiver too long?
e Is the reception disturbed by metal objects
in the transmission path?
f Is it possible to improve the reception
when you turn the receiving antennas (1)?
g Has the interference suppression been set
too high with the control SQUELCH (13)?
( step 6)
☞
5) Switch on the following audio device or
advance the corresponding mixer control .
Speak / sing into the microphone and match
the output level of the receiver to the input
of the following device with the control VOL-
UME (12) .
6) Use the control SQUELCH (13) to adjust the
threshold value at which the interference
suppression is to be activated . The interfer-
ence suppression will mute the receiver in
speech / music pauses when interfering signals
are received and their levels are below the
threshold value adjusted . A high threshold
value, however, will also reduce the trans-
mission range of the microphone system: If
the power of the radio signal falls below the
threshold value adjusted, the receiver will also
be muted . Therefore, adjust a high threshold
value (turn the control towards MAX) when
the reception is good and a low value (turn
the control towards MIN) when the distance
between the microphone and the receiver
is long .
7) The microphone has a lock feature . To ac-
tivate the lock, set the switch LOCK (18) in
the battery compartment to the position ON .
The displays shows a key symbol and it will
not be possible to switch off the microphone
with the switch (16) or to set it to a different
channel via IR signal . However, it will still be
possible to mute the microphone when you
set the switch (16) to the mid-position or the
lower position .
All rights reserved by MONACOR
be reproduced in any form or by any means for any commercial use.
☞ chapter 4 .3)
INTERNATIONAL GmbH & Co. KG. No part of this instruction manual may
®
8) After operation, switch off the devices with
the corresponding switch (9, 16) . The power
supply unit of the receiver has a low power
consumption even when the receiver is
switched off . Therefore, disconnect the
power supply unit from the mains socket
when the microphone system is not used for
a longer period of time .

6 Specifications

Carrier frequency
range: � � � � � � � � � � � � � 863 – 865 MHz
Transmission range: � � � approx� 30 m
RF S / N ratio: � � � � � � � � 105 dB
Audio frequency range: 50 – 18 000 Hz, ±3 dB
Dynamic range: � � � � � � 120 dB
THD: � � � � � � � � � � � � � � < 0�5 %
Ambient temperature: � 0 – 40 °C
Receiver
Audio outputs
MIC OUT: � � � � � � � � � 25 mV/10 kΩ; XLR, bal�
LINE OUT: � � � � � � � � � 350 mV/10 kΩ;
Power supply: � � � � � � � via power supply unit
Dimensions, weight: � � 152 × 38 × 120 mm, 482 g
Wireless microphone
Transmission
power (EIRP): � � � � � � � < 10 mW (HI), 1�0 mW (LO)
Polar pattern: � � � � � � � cardioid
Power supply: � � � � � � � 2 × 1�5 V battery, size AA
Dimensions, weight: � � ⌀ 52 mm × 275 mm, 235 g
Subject to technical modification .
channels: see page 3
6�3 mm jack, unbal�
provided and connected to
~ 230 V / 50 Hz
11