Internal Light - Teka RVI 10024 GBK Manual Del Usuario

AND SETTING THE TEMPERATURE CONTROL
 Control System Instruction

" DISPLAY "
To shows the set temperature.

" " Button
Used to rise the temperature 1 ℃;

" " Button
Used to down the temperature 1 ℃;

" " Button
To control the inner light turn on/off.
(Press this button, the light is on, and the light is not controlled by door. Press this
button again, the light is off, and the light is controlled by door.)
NOTE: It will take 3 seconds for LED light completely went out after turning off the light.

" " Button
To control this appliance turn on/off.
(Press this button, the power is on. Press this button with 3 seconds again, the power is
off.)
 Setting The Temperature Controls

The temperature range 5℃～18℃ .

When the system enter the set up temperature. Each press once the
temperature setting will increase or lower 1℃,When the temperature setting reach the
upper limit 18℃ and lower limit 5℃, the temperature setting will not increase or lower.

If you want to reveal actual temperature, please press and hold the " UP " or " DOWN "
button for 3 seconds, the LED will flash and display the actual temperature. After
stopping pressing the button for 5 seconds, LED figure will stop flash, then revert back to
display the set temperature.

Flashing LED = Cabinet temperature
Steady LED = Set temperature
 Internal light

In order to reduce energy consumption, the LED light within this wine wine cooler will
automatically switch off when closed the door. If you would prefer the LED light to
remain on continuously, this is possible. Please press and hold the "LIGHT" bottom for 1
seconds, the display will show "LP". After 4 seconds the display will revert back to
normal and the light will remain on until manually switched off.
OPERATING YOUR WINE COOLER
27
or button, the