Evolution R90 JGS Li Instrucciones Originales página 4

VIBRATION
Note: The vibration measurement was made under
standard conditions in accordance with: EN 62841-1
& EN 62841-2-11
Warning: Wear hearing protection!
The declared vibration total value has been
measured in accordance with a standard test
method and may be used for comparing one tool
with another.
The declared vibration total value may also be used
in a preliminary assessment of exposure.
(1.6) WARNING: When using this machine the
operator can be exposed to high levels of vibration
transmitted to the hand and arm.
It is possible that the operator could develop
"Vibration white finger disease" (Raynaud
syndrome). This condition can reduce the sensitivity
of the hand to temperature as
well as producing general numbness.
Prolonged or regular users of this machine should
monitor the condition of their hands and fingers
closely. If any of the symptoms become evident,
seek immediate
medical advice.
• The measurement and assessment of human
exposure to hand-transmitted vibration in the
workplace is given in:
EN 62841-1 & EN 62841-2-11
• Many factors can influence the actual vibration
level during operation e.g. the work surfaces
condition and orientation and the type and
condition of the machine being used. Before
each use, such factors should be assessed, and
where possible appropriate working practices
adopted. Managing these factors can help
reduce the effects of vibration:
Handling
• Handle the machine with care,
allowing the machine to do the work.
• Avoid using excessive physical effort on any of
the machines controls.
• Consider your security and stability,
and the orientation of the machine
during use.
Work Surface
• Consider the work surface material;
its condition, density, strength,
rigidity and orientation.
WARNING: The vibration emission during actual
use of the power tool can differ from the declared
total value depending on the ways in which the
tool is used.
The need to identify safety measures and to
protect the operator are based on an estimation
www.evolutionpowertools.com
of exposure in the actual conditions of use (taking
account of all parts
of the operating cycle, such as the times the tool is
switched off, when it is running idle,
in addition to trigger time).
(1.7) LABELS & SYMBOLS
WARNING: Do not operate this machine
if warning and/or instruction labels are missing or
damaged. Contact Evolution
Power Tools for replacement labels.
Note: All or some of the following symbols may
appear in the manual or on the product.
Symbol Description
V
A
min (RPM)
-1
~
Alternating Current
n o
No Load Speed
Wear Safety Goggles
Wear Ear Protection
Keep hands away
Wear Dust Protection
Wear Hand Protection
UKCA Certification
TUV SUD Certification
(RCM) Regulatory Compliance
Mark for electrical and electronic
equipment. Australian/New
Zealand Standard
Waste electrical and
electronic equipment
4
Volts
Amperes
Speed
Do Not Touch,
CE Certification
Read Manual
WARNING