Maintenance And Service; Technical Data - stayer IS L20 Manual De Instrucciones

6. Maintenance and Service

Maintenance and cleaning
Remove the battery from the power tool before
carry-ing out work on the power tool (e.g.
maintenance, changing tool, etc.). The battery
should also be re-moved for transport and
storage. There is risk of injury from unintentionally
pressing the on/off switch.
To ensure safe and efficient operation, always keep
the power tool and the ventilation slots clean.
After-Sales Service and Application Service
Our after-sales service responds to your questions
concern-ing maintenance and repair of your product as
well as spare parts. You can find explosion drawings and
information on.
Repair service
The technical service will provide you advice regarding
questions you may have on the repair and maintenance
of your product as well as on spare parts.
You may also obtain exploded views and information on
spare parts on the internet under:info@grupostayer.com
Warranty
Warranty card
lncluded in the documentation that accompanies this
equipment, you should find the warranty card. You should
fill out the card completely and retum to vendar with a copy
of purchasing receipt or invoice and you should receive a
receipt.
Note: lf you cannot find the warranty card within the
documentation,youmust ask for it through your supplier.
The warranty is limited only to manufacturing defects and
expire if pieces have been removed or manipulated or
repaired otherthan themanufacturer.
Transport
The contained lithium-ion batteries are subject to the
Dangerous Goods Legislation requirements. The user can
transport the batteries by road without further requirements.
When being transported by third parties (e.g.: air transport
or forwarding agency), special requirements on packaging
and labelling must be observed. For preparation of the
item being shipped, consulting an expert for hazardous
material is required.
Dispatch batteries only when the housing is undamaged.
Tape or mask off open contacts and pack up the battery
in such a manner that it cannot move around in the
packaging. Please also observe possibly more detailed
national regulations.
Disposal and recycling
The machine, accessories and packaging should be
sorted for environmental-friendly recycling.Only for EC
countries:
Do not dispose of power tools into household
waste!
According the European Guideline 2012/19/CE
for Waste Electrical and Electronic Equipment
and its implementation into national right,
power tools that are no longer usable must be collected
ENGLISH
19
separately and disposed of in an environmentally correct
manner. Subject to change without notice.
Battery packs/batteries:
Li-Ion:
Please observe the instructions in
section "Transport". Do not dispose of
battery packs/batteries into household
waste, fire or water. Battery packs/
batteries should be collected, recycled
or disposed of in an environmental-
friendly manner.
Only for EC countries:
Defective or dead out battery packs/batteries must be
recycled according the guideline 2006/66/CE.
7. Regulations

7.1 Technical Data

= Battery
= Voltage
V
= Battery Power
= charging time
= no load speed
rpm
= Percussions
ipm
=Torque
= Inserting chuck
=Weigth
= Sound power level
=Sound pressure level
=Vibration
The values given are valid for nominal voltages [U]
230/240 V ~ 50/60 Hz - 110/120 V ~ 60Hz. For lower
voltage and models for specific countries, these values
can vary. Please observe the article number on the type
plate of your machine. The trade names of the individual
machines may vary.
19
es
gb
it
fr
tr
pl
cz
gr