Stroller Assembly - Joovy Qool Manual De Instrucciones

Stroller Assembly

IMPORTANT NOTE: Please refer to the end of this manual for all photos
that are referenced in parentheses in the instructions below.
Unpacking the Product
• Remove everything from the box – stroller frame, seat, two seat brackets, two rear wheels, two
front wheels, canopy, tray, parent organizer and documents (not shown).
• Discard all packaging materials properly including plastic coverings.
• DO NOT allow children to play with any packaging materials.
I WARNING:
tools required.
Unfolding the Stroller
NOTE: Remove packing foam from rear frame assembly to ensure stroller locks in the open position.
• Orient the stroller with the handlebar facing upward and closest to you. Release the safety latch
located on the left side of the stroller. (1)
• Pull upwards on the handlebar until the stroller is fully erected and the latching mechanism on
each side engages. (2)
• Visually check and gently push downward on the handlebar to ensure that the stroller is
completely opened and locked before ANY use of the product.
I WARNING:
unfolding. ALWAYS ensure the folding mechanism on each side of
handlebar is fully engaged when the stroller is in the unfolded position.
This will prevent collapse of the stroller. Possible pinching hazard – Be
careful when unfolding the stroller.
Installing/Removing the Front Wheels
• Slide one front wheel onto the front wheel post until it clicks in place. (3) Repeat for other wheel.
Pull on the wheels to ensure they are installed properly.
• To remove, press the metal release button on the back of the front wheel post and pull away from
the stroller. (4)
Installing/Removing the Rear Wheels
• Install a rear wheel by sliding the axle into the hole in the wheel hub until it clicks into place. (5)
Repeat for other wheel. Pull on the wheels to ensure they are installed properly.
• To remove, push down the metal release buttons beneath the rear axle bar and pull the wheels
from the stroller. (6)
Installing/Removing the Seat
• Seat brackets can be placed in the high (rearmost) or the middle position on the stroller frame. (7)
• Slide the seat brackets onto the stroller frame at the desired height until they click into place. (8)
Both seat brackets must be at the same height.
• Place the seat onto the stroller so that the male brackets on the bottom of the seat line up with the
female brackets on the stroller frame.
• Push down on both sides of the seat until both sides snap into place. (9) Pull up on the seat on
both sides to ensure it is secure.
• The seat can be placed on the stroller forward-facing or rear-facing. (10)
6
Adult assembly is required for this product. No
Keep children away from stroller while