Stroller Assembly; Unfolding The Stroller - Joovy Caboose S Manual De Instrucciones

Stroller Assembly

I WARNING:
tools required. NOTE: Remove all packing foam from frame assembly to
ensure stroller locks in the open position.

Unfolding the Stroller

• Put the stroller upside down with the handlebar on the ground.
• Stand opposite the handlebar facing the light gray brake pedals.
• Insert the standing bar (1) into the rear tubing by sliding both sides at the same time. Depress the
spring pins until they click into place.
• Flip the stroller over with the handlebar on top.
• Release the safety latch (located on the right side) by pulling the lock lever away from the frame.
(2)
• Pull the handlebar upward while putting one foot on top of the stand-on platform. (3) Keep pulling
until the stroller is fully open and the latching mechanism on each side engages. Make sure to hear
an audible click. (4)
• Visually check and gently push downward on the handle to ensure that the stroller is completely
opened and locked before ANY use of the product.
I WARNING:
unfolding. ALWAYS ensure the folding mechanism on each side of bottom
of the handlebar is fully engaged when the stroller is in the opened
position. This action will prevent collapse of the stroller. Possible pinching
hazard – Be careful when unfolding the stroller.
Installing/Removing the Rear Wheels
• Install a rear wheel by sliding the axle into the hole in the wheel hub until it clicks into place. (5)
Repeat for the other wheel. Pull on the wheels to ensure they are installed properly. (6)
• To remove, pull down the metal release button on the rear wheel bracket and pull the wheels from
the stroller. (7)
8
Adult assembly is required for this product. No
Keep children away from stroller while