Stroller Assembly
IMPORTANT NOTE: Please refer to the end of this manual for all photos
that are referenced in parentheses in the instructions below.
Unpacking the Product
• Remove everything from the box – stroller, two canopies, two rear wheels, two front wheel sets,
parent organizer, tray, two Cup Holders, two infant car seat adapters, and documents (not shown).
• Discard all packaging materials properly including plastic coverings.
• DO NOT allow children to play with any packaging materials.
I WARNING:
tools required.
Unfolding
• Keep children away from stroller while unfolding.
• Release the folding lock located on the right side by lifting the lever off of the catch. (1)
• Lift up on the handle of the stroller until the frame snaps into its open locked position.
CAUTION: While unfolding the stroller, be careful to keep your fingers from being pinched by
moving parts.
NOTE: Remove packing foam from rear frame assembly to ensure stroller locks in the open position.
• Lock BOTH the safety latches on both sides of the stroller. (2)
• Ensure that the safety latches are secured before ANY use of the stroller.
I WARNING:
BOTH sides of the stroller when it is in the unfolded use position. This
will prevent collapse of the stroller should the handle trigger locks be
accidentally opened. Possible pinching hazard – Be careful when
unfolding the stroller.
Installing/Removing Rear Wheels
• Install one rear wheel by sliding it onto the axle until it clicks into place. (3)
• Repeat for other rear wheel.
• Pull on the wheels to ensure they are installed securely.
• To remove each wheel, push up the plastic tab on the rear axle and then pull the wheel outward
from the stroller. (4)
Installing/Removing the Front Wheels
• Place the front wheel sets onto the front wheel posts until they click in place. (5)
• Pull on the wheel sets to ensure they are installed securely.
• To remove each wheel, press down on the plastic tab in the hole at the bottom of the front wheel
and then pull the wheel outward from the stroller. (6)
Front Wheel Locks
The front wheels can be set to swivel or lock.
• To lock the front wheels, rotate each wheel set so that it points forward.
• Pull up on the locking lever to engage the swivel lock. (7)
• To unlock the wheels (swivel mode) push down on the lever.
Installing and Operating the Canopies
These steps are for BOTH canopies.
6
Adult assembly is required for this product. No
ALWAYS secure the safety latches on