Evolution R185 CMS Li Instrucciones Originales página 20

USE OF EVOLUTION ACCESSORIES
DUST BAG
A dust bag can be fitted to the extraction port at the rear of
the machine. The dust bag is for use when cutting wooden
materials only.
• Slide the dust bag over the dust extraction port, ensuring that
the spring clip grips the port holding the dust bag securely in
place (Fig. 28).
Note: For operational efficiency empty the dust bag when it
becomes 2/3 full. Dispose of the contents of the dust bag in an
environmentally responsible way. It may be necessary to wear a
dust mask when emptying the dust bag.
Note: A workshop vacuum extraction machine can be attached
to the dust extraction port if required. Follow the vacuum
manufacturers instructions if such a machine is fitted.
WARNING: Do not use the Dust Bag when cutting
metallic materials.
EXTRACTION PORT ADAPTOR TUBE
Use the Adaptor Tube to connect the extraction port of the machine
to suitable commercial workshop vacuum extraction equipment
(not supplied) which have ø30mm internal bore hoses or inlet ports.
(Fig.29)
MAINTENANCE
Note: Any maintenance must be carried out with the machine
switched off and the battery removed from the machine. Check
that all safety features and guards operating correctly on a regular
basis.
Only use this machine if all guards/safety features are fully
operational. All motor bearings in this machine are lubricated for
life. No further lubrication is required.
Use a clean, slightly damp cloth to clean the plastic parts of the
machine. Do not use solvents or similar products which could
damage the plastic parts.
CLEANING THE MACHINE'S BLADE
GUARDING SYSTEM
WARNING: Only clean blade guarding system with the battery
removed from the machine.
The operator must wear all the relevant PPE equipment and also
ensure the safety of any close by colleagues or observers when
cleaning this machine.
Note: The frequency with which the guarding system needs
attention will largely depend upon service conditions and the type
of material that is being routinely cut. Some wood based products,
for example, may contain resins or produce dust that can build up on
www.evolutionpowertools.com
Fig. 28
Fig. 29
20