Teka RVU 10008 GBK Manual Del Usuario página 31

1. Open the door to a 90 degrees angle, take out the 2 screws (2) from lower door axis (3),
remove the door (4), Remove the axis plate (3) from the door, (Fig. A).
2. Unscrew the screw (11) located underneath the doorframe and the limit device (10), and
relocate it at left end side of the door frame. (Fig. A/B)
3. Take out the 3 hinge screws (6) from the top hinge (right) (5) and remove it. (Fig. C)
4. Remove decorative nail (8) from left top of cabinet and install spare top hinge (Left) (7) at
left top of cabinet with 3 screws. (Fig. D)
5. Following the above procedure, install the spare lower hinge to the left (9). (Fig. E)
6. Install and aligned the door.
7. Insert the plastic caps to cover the holes(8).
USING THE FOOT SLIDERS
If you want to adjust the height over 820mm, please install the product using the foot sliders
provided. These are provided to help prevent the feet catching on the floor when sliding the
appliance into the aperture. Place the back foot in the location marked 'Back' below and the
front foot in the location marked 'Front'. Once fitted to both sides of the wine cabinet the
appliance can be gently positioned into the aperture, taking care not to place excess
pressure
on the feet when locating the cabinet.
Back
Front
Front
Back
Foot
29