Barrette BOM-34107467 Instrucciones De Instalación página 3

Rail Installation
1.
Installing Post Jackets and Base Trim
Over 4x4 Wood Posts:
Slide Post Jacket and base trim over wood 4 x 4.
Plastic post spacers are included in 5 x 5 Pro Rail
Post Jacket and t tight over 4 x 4 wood post.
OR
Installing Post Jackets and Base Trim
with Post Install Kit:
Slide Post Jacket and base trim over steel Post
Install Kit (sold separately) - See separate Post
Install Kit instructions for installation details.
2.
Preparing Bottom Rails:
If using full length panels, skip to Step 5.
Place bottom rail across post opening leaving
equivalent spacing from the last baluster and
post on each end (Fig. 1).
3.
Mark Rails:
Mark rail ush to post (Fig. 2).
4.
Cut Rails:
Assuming posts are plumb, align top rail with
bottom rail and cut to proper length.
5.
Installing Center Supports (Fig. 3):
a. One support brace is included with
6' railing kits.
b. Two support braces are included with
8' railing kits.
Install support braces evenly across span of
railing section.
6.
Temporary Spacers:
Cut two 2
(not included) to insert under ends of bottom rail
to temporarily assist in aligning rail section (Fig. 4).
⁄ ⁄ " tall temporary wood spacer blocks ⁄ ⁄
7 7 7
8 8
Post Post
Support Brace Support Brace
Spacer Blocks Spacer Blocks Spacer Blocks Spacer Blocks Spacer Blocks Spacer Blocks Spacer Blocks Spacer Blocks Spacer Blocks Spacer Blocks Spacer Blocks Spacer Blocks Spacer Blocks Spacer Blocks Spacer Blocks Spacer Blocks Spacer Blocks Spacer Blocks Spacer Blocks Spacer Blocks Spacer Blocks Spacer Blocks
Fig. 1
Fig. 2
Fig. 3
Fig. 4
3