Barrette BOM-34107467 Instrucciones De Instalación página 6

4.
Install Balusters:
Assemble stair rail section by snapping balusters
into routed holes. All lock tabs on balusters must
face outer edge of routed holes in rails (Fig. 4).
5.
Install Bottom Rail Brackets:
Attach bottom rail bracket to side of bottom
rail with one provided #10 x 1" at head screw.
Brackets should align ush to the angled edge/cut
of the bottom rail. Repeat on both ends of bottom
rail, each side (Fig. 5).
6.
Mark for Brackets:
Carry assembled stair rail section and place
between installed posts and directly on top of
temporary
On each post, mark under top rail where at area
on rail meets the post. This will aid in the proper
placement of the top rail brackets (Fig. 6).
7.
Installing Top Brackets:
Remove the stair section from between posts.
Place the top of the top rail bracket along the
previously marked post lines (2 screw side faces
up). Install the two top rail brackets into posts
with three #10 x 2
8.
Attaching Top Rail to Brackets:
Re-carry assembled stair rail section and place
between installed posts, making sure top rail ts
snug over the installed top rail brackets. Bottom
rail should be resting directly on top of temporary
⁄ ⁄ ⁄ " spacer board. ⁄
5 5 5
4 4
To locate side screw placement for top rail
brackets, (included in bracket packaging) tape
side screw template to side of top rail. Using
drill bit, predrill through marked hole into rail and
bracket. Screw provided #10 x 1" pan head screw
through hole (Fig. 8).
9.
Installing Bottom Rail Brackets:
Using provided #10 x 1" at head screws, attach
the bottom rail brackets to both the top and
bottom stair posts (2 screws per bracket) (Fig. 9).
Snap bottom rail bracket covers over each bottom
rail bracket to hide screws.
6
⁄ ⁄ " spacer board. ⁄ ⁄
5 5 5
4 4
⁄ ⁄ ⁄ ⁄ " screws each (Fig. 7).
1 1 1
2 2
⁄ ⁄ " ⁄ ⁄
1 1 1
8 8
Fig. 4
Fig. 5
Fig. 6
Fig. 7
Fig. 8
Fig. 9