Publicidad
Idiomas disponibles
Idiomas disponibles
2. As soon as the display shows all symbols, you
can have the rests fed out by holding the
"Capacity" button.
3. Afterwards, start a manual cleaning program
using the "Cleaning" button.
Descaling
Treat your product with care and only use filtered water. You should additionally
descale it regularly. We recommend descaling after every 50th preparation process,
or whenever you clearly notice limescale on or in the machine. To descale, proceed
as follows:
1.
Add 3 tsp baking soda into the water container and fill it with water.
2.
Start any program with 300 ml.
3.
Stop the preparation as soon as the device starts pumping water into the
mixing chamber (approx. 5-10 seconds) by removing the water tank and
disconnecting your product from the power. Wait 1 hour.
4.
Plug it again and allow the program to run to the end.
5.
Afterwards, run through two preparation programs without any ingredients
using a quantity of 1 000ml each time. Repeat the process, if required. Now the
device is good to go.
Replacement
If the blades get blunt after a period use, you can replace them yourself. Only use
original spare parts!
Attention! Exercise particular care when handling the blades, also if they are dull.
There is a risk of injury!!!
1.
Ensure that it is not connected to the power supply
2.
Use the rugged tools such as a long screwdriver. Protect the base of the
mixing chamber, e.g. by placing several layers of paper or a fitting piece of silicone
underneath the blades, to prevent scratching the coating.
Publicidad
