Troubleshooting - Silverline 980960 Manual

EN
Storage
•
Store this tool carefully in a secure, dry place out of the
reach of children
•
For long-term storage, remove batteries and store
separately
Disposal
Li-ion batteries should not be disposed of with household waste. If you do
not know of a li-ion battery recycling centre in your area, contact your local
authority or original dealer for advice on disposal of li-ion batteries.
Always adhere to national regulations when disposing of power tools that
are no longer functional and are not viable for repair.
•
Do not dispose of power tools, batteries or other waste
electrical and electronic equipment (WEEE), with household
waste
• Contact your local waste disposal authority for information
on the correct way to dispose of power tools and batteries

Troubleshooting

Problem Possible cause
completely
Defective Battery
Defective ON/OFF
No function when
ON/OFF Switch (7)
is operated
Carbon brushes
Disc not suitable for
the material being
Slow cutting
performance
Too much pressure
exerted on to the
Disc is overly worn,
damaged, or
Disc is off
centre/vibrating
eccentrically
Disc not fitted
silverlinetools.com
Original Instructions
Solution
Battery (8) Recharge Battery or
replace with a fully
discharged charged Battery
Replace Battery
Have the ON/OFF
Switch replaced by
an authorised
Switch
Silverline service
centre
Have the carbon
brushes replaced by
an authorised
worn
Silverline service
centre
Contact authorised
Faulty tool Silverline service
centre for repair
Fit compatible disc
cut
Reduce the
pressure applied to
tool the tool
Replace the disc
deformed
Remove and refit
correctly the disc correctly
14