Troubleshooting - Silverline 268953 Manual De Instrucciones

GB
Storage
• Store this tool carefully in a secure, dry place out of the reach of children

Troubleshooting

Problem
Rotary tool bit, not spinning correctly
Machine will not start
Excessive vibration when in use
8
Possible cause
Flexible drive shaft, not correctly fitted to the adaptor at the
Female Connector (10)
Collet (24) is loose
Plug fuse damage
Circuit breaker switched off
Tool fault
Wheel out of balance
Wheel loose
Wheel damaged
Disposal
Always adhere to national regulations when disposing of power tools that are no longer
functional and are not viable for repair.
• Do not dispose of power tools, or other waste electrical and electronic equipment
(WEEE), with household waste
• Contact your local waste disposal authority for information on the correct way to
dispose of power tools
Solution
Check and re-fit the Male Connector (1), as described in
'Fitting the flexible rotary tool'
Check that the Collet corresponds to the size of the mandrel, re-tighten the collet
Replace fuse
Reset circuit breaker
Have the tool serviced by an authorised Silverline service centre
Dress wheels
Turn off immediately and re-tighten wheel fittings
Turn off immediately and replace the wheel