Fitting the outlet DN 150
(Only ProfiClear Premium L Standing Bed Module)
How to proceed:
1. Insert the seal in the container wall from the outside.
2. Place the outlet on the seal.
– Ensure that the marking points up and is aligned with the holes in the container wall.
3. Use three oval head screws to screw the outlet to the container wall from the inside.
– Tighten the screws diagonally to ensure that the seal is uniformly applied.
– If you are using a cordless screwdriver: Do not set the screwdriver to "drill" to prevent dam-
age to the self-tapped thread. Then re-tighten the screws with a Torx screwdriver.
EN
Proficlear0297
27