Technical Data - GreenWorks GPW1501 Manual Del Operador

PROBLEM POSSIBLE
CAUSE
The water supply
is not sufficient.
The pump is draw-
ing in air.
The output pres-
sure varies high
and low.
The water intake
filter is clogged.
The supply volt-
age is low.
The gun, hose or
nozzle are calci-
fied.
English
SOLUTION PROBLEM
Open water supply The motor buzzes,
fully. Check gar- but the machine
den hose for kinks, does not start.
leaks, or blockage.
1. Make sure that
the hoses and
fitting are air-
tight.
2. Turn "OFF"
machine.
3. Purge pump
by squeezing
trigger gun un-
til a stead flow
of water
comes out the
spray tip.
Remove the filter
and Rinse in warm
water.
Make sure that on-
ly the pressure
washer is running
on the circuit.
Run distilled vine-
gar through deter-
gent tank.
There is no water.
8
Model No.
Universal Motor
Max. Pounds Per
Square Inch Pres-
sure
Rated Gallons Per
Minute
Maximum Inlet Wa-
ter Temperature
11
POSSIBLE
CAUSE
The supply volt-
age is low.
The pump system
has residual pres-
sure.
Voltage loss due to
use of an improper
extension cord.
Pressure washer
not used for long
periods.
Residual friction
among compo-
nents. Unit might
emit a humming
noise.
The water supply
is off.
The garden hose is
kinked..

TECHNICAL DATA

GPW 1501
120V~ 60 Hz, 13
Amps
1500 PSI
1.2 GPM
104 °F (40 °C)
EN
SOLUTION
Make sure that on-
ly the pressure
washer is running
on the circuit.
1. Turn "OFF"
the machine.
2. Pull the spray
gun trigger on
spray wand to
release pres-
sure.
3. Turn the ma-
chine "ON".
Disconnect the ex-
tension cord, and
connect the ma-
chine directly into
the outlet.
Call customer
service.
1. Disconnect the
water supply.
2. Power "ON"
the machine
for 2 to 3 sec-
onds.
3. Repeat the
above step a
couple of
times or until
the motor
starts.
Turn the water
supply on.
Remove kink in
garden hose.
GPW 1602
120V~ 60 Hz, 13
Amps
1600 PSI
1.2 GPM
104 °F (40 °C)