Technical Data - GreenWorks GPW 2006 Manual Del Operador

PROBLEM POSSIBLE
CAUSE
The machine does The diameter of
not reach high garden hose is too
pressure. small.
Water supply is re-
stricted.
The water supply
is not sufficient.
Spray tip has not
be installed onto
the spray wand
properly.
The water intake
filter is clogged.
The water supply
is not sufficient.
The pump is draw-
ing in air.
The output pres-
sure varies high
and low.
The water intake
filter is clogged.
The supply volt-
age is low.
The gun, hose or
nozzle are calci-
fied.
English
SOLUTION PROBLEM
Replace with a 1" The motor buzzes,
(25 mm) or 5/8" but the machine
(16 mm) garden does not start.
hose.
Check garden hose
for kinks, leaks,
and blockage.
Open the water
supply fully.
Install desired
spray tip to end of
wand.
Remove filter and
rinse in warm wa-
ter.
Open water supply
fully. Check gar-
den hose for kinks,
leaks, or blockage.
1. Make sure that
the hoses and
fitting are air-
tight.
2. Turn "OFF"
machine.
3. Purge pump
by squeezing
trigger gun un-
til a stead flow
of water
comes out the
spray tip.
There is no water.
Remove the filter
and Rinse in warm
water.
Make sure that on-
ly the pressure
8
washer is running
on the circuit.
Universal Motor
Run distilled vine-
gar through deter-
Max. Pounds Per Square Inch
gent tank.
Pressure
Rated Gallons Per Minute
Maximum Inlet Water Temper-
ature
Cleaning Units
Weight
13
POSSIBLE
CAUSE
The supply volt-
age is low.
The pump system
has residual pres-
sure.
Voltage loss due to
use of an improper
extension cord.
Pressure washer
not used for long
periods.
Residual friction
among compo-
nents. Unit might
emit a humming
noise.
The water supply
is off.
The garden hose is
kinked..

TECHNICAL DATA

120V~ 60 Hz, 14 Amps
2000 PSI
1.2 GPM
104 °F (40 °C)
2400 C.U.
33 lbs. (15.1 kg)
EN
SOLUTION
Make sure that on-
ly the pressure
washer is running
on the circuit.
1. Turn "OFF"
the machine.
2. Pull the spray
gun trigger on
spray wand to
release pres-
sure.
3. Turn the ma-
chine "ON".
Disconnect the ex-
tension cord, and
connect the ma-
chine directly into
the outlet.
Call customer
service.
1. Disconnect the
water supply.
2. Power "ON"
the machine
for 2 to 3 sec-
onds.
3. Repeat the
above step a
couple of
times or until
the motor
starts.
Turn the water
supply on.
Remove kink in
garden hose.