Using Accessories - Flex MT 18.0-EC C Instrucciones De Funcionamiento Originales

MT 18.0-EC
during operation, please contact customer
service or an authorized service center for
assistance.
Setting the speed (See figure M)
■ There are five speed levels that can be
changed using the speed setting buttons
M-1. Press the "
speed. Press "
speed. The LED lights above the numbers
indicate the current speed level.
The speed level can be set before the tool
is turned on or when the tool is already in
operation.
The approximate OPM (oscillations per minute) are:
Speed Level
1
2
3
4
5
If the tool is OFF:
■ Press one of the speed setting buttons.
This will "wake up" the control panel M-2
and the LED lights will indicate the current
speed level.
■ Change the speed level by pressing the "
" or " " buttons.
■ After 15 seconds of inactivity, the LED
lights on the control panel will turn off. The
memory function will remember and revert
to the last active speed level the next time
one of the speed setting buttons is pressed
or the tool is turned on.
If the tool is already ON:
■ Change the speed level by pressing the "
" or " " buttons. You will feel and hear
the speed change and the LED lights will
indicate the current speed level.
■ After you turn the tool off, the memory
function will remember and revert to the
last active speed level the next time the
tool is turned on.
WARNING!
Adjust the speed only when the tool is
off or when the tool is running at no-load.
Make sure to hold the tool firmly within
the soft grip area with one hand, keeping
the tool under control, when adjusting the
" button to increase the
" button to decrease the
/min (OPM)
10000
12000
15000
18000
20000
speed when running at no-load. Failure to
obey this caution could cause loss of control
and result in serious personal damage.

Using accessories

WARNING!
Use sharp, undamaged accessories only.
Deformed or blunt or otherwise damaged
accessories can break causing injuries or
property damage.
WARNING!
Do not attach the accessories in such a way
that they face backward. Operation in this
position may cause serious injury.
A range of available accessories easily turn
the tool into a saw or into a sander, into a
scraper or a grout remover.
NOTE: Not all accessories are included
with your tool and should be purchased
separately.
Accessories with STARLOCK interface from
other manufacturers should be compatible
with this tool.
Application tool
STARKLOCK
STARKLOCK PLUS
STARKLOCK MAX
Cutting
The plunge saw blades are ideal for making
precise cuts in tight areas, close to edges or
flush to a surface. Set the tool to a medium
speed (3) for greater control when making
the initial plunge. After making the initial cut,
the speed can be increased for faster cutting.
When flush cutting, do not force the tool. A
strong vibration during the plunge cut is an
indicator that you are applying too much
pressure – let the speed of the tool do the
work.
MT 18.0-EC
17