Regulations; Technical Data; Eu Declaration Of Conformity - stayer ISL120K Manual De Instrucciones

Battery packs/batteries:
Li-ion:
Please observe the instructions in
section "Transport".
D o n o t d i s p o s e o f b a t t e r y
packs/batteries into household waste,
fire or water. Battery packs/batteries
should be collected, recycled or disposed of in an
environmental-friendly manner.
Only for EC countries:
Defective or dead out battery packs/batteries must be
recycled according the guideline 91/157/EEC.

7. Regulations

7.1 Technical Data

= Battery
= Voltage
= Battery Power
= charging time
= no load speed
rpm
= Percussion
ipm
= Torque
Ins = Inserting chuck
= Wood cut
max
= Steel cut
max
= Weigth
L = Sound power level
WA
L = Sound pressure level
A
P
= Vibration
The values given are valid for nominal voltages [U] 230/240 V ~
50/60 Hz - 110/120 V ~ 60Hz. For lower voltage and models for
specific countries, these values can vary. Please observe the
article number on the type plate of your machine. The trade
names of the individual machines may vary.
Noise/Vibration Information
Measured sound values determined according to EN 60745.
Typically the A-weighted noise levels of the product are:
Sound pressure level 87 dB(A); Sound power level 98 dB(A).
Uncertainty K =3 dB.
Wear hearing protection!
Vibration total values a (triax vector sum) and uncertainty K
h
determined according to EN 60745:
Impact tightening of fasteners of the maximum capacity of the tool:
2 2
a =9m/s , K =1.5 m/s .
h
ENGLISH
19
The vibration emission level given in this information sheet has
been measured in accordance with a standardised test given in
EN 60745 and may be used to compare one tool with another. It
may be used for a preliminary assessment of exposure.
The declared vibration emission level represents the main
applications of the tool. However if the tool is used for different
applications, with different accessories or poorly maintained, the
vibration emission may differ. This may significantly increase the
exposure level over the total working period.
An estimation of the level of exposure to vibration should also take
into account the times when the tool is switched off or when it is
running but not actually doing the job. This may significantly
reduce the exposure level over the total working period.
Identify additional safety measures to protect the operator from the
effects of vibration such as: maintain the tool and the accessories,
keep the hands warm, organisation of work patterns.

7.2 EU declaration of conformity

The undersigned: STAYER IBERICA, S.A.
With address at:
Calle Sierra de Cazorla, 7
Área Empresarial Andalucía - Sector 1
28320 PINTO (MADRID)
Tel.: +34 902 91 86 81 / Fax: +34 91 691 91 72
CERTIFIES
That the machine:
Type: IMPACT WRENCH
/ CORDLESS DRILL/SCREWDRIVER
Models: ISL120 / PBL120
We declare under our sole responsibility that this product is
in conformity with the following standards or standardized
documents: EN 60745 according to EU Regulations
2004/108/CE, 2006/42/CE
Ramiro de la Fuente
Managing Director
19