Inserting And Removing Discs; Inserting Discs; Ejecting Discs; Forcing Disc Ejection - Tascam CD-400U DAB Manual Del Usuario

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

Inserting and removing discs

Inserting discs

Insert the disc part way with its labeled side up.
Push the disc in further until just before it disappears. It will auto-
matically be drawn in to the slot.
CAUTION
i Discs cannot be inserted when the power is off.
i If the disc becomes stuck during insertion, for example, and
is difficult to push, do not try to force it in. Pull the disc out
once and press the EJECT button. Then, try inserting it again.
(Trying to force the disc in could scratch it or damage the unit.)
i If a disc other than a playable CD is inserted or a disc is insert-
ed upside down, the unit will automatically eject it.
i 8cm CDs cannot be used. If an 8cm CD is inserted, it will auto-
matically be ejected.

Ejecting discs

Press the main unit or remote control EJECT button.
When the disc is partially ejected, hold the edge and pull it out.
CAUTION
When the power is off, the main unit and remote control
EJECT buttons will not function.

Forcing disc ejection

Press and hold the EJECT button for at least 10 seconds to force
the disc to eject. (This will eject discs even when No Disc appears
on the Home Screen)
3 – Preparation

Inserting and removing SD cards

Inserting SD cards

Insert an SD card into the SD card slot on the front of the unit to
enable playback and dubbing by this unit.
NOTE
SD cards can be inserted whether or not the unit is on or off.
0 Inserted SD cards with the correct orientation.
0 The label should be up and the connector should be inserted
toward the back.

Removing SD cards

Turn the unit off or stop operation before removing an SD card.
CAUTION
Do not remove an SD card when the unit is operating (includ-
ing playing back or writing data to the SD card). Doing so
could cause proper dubbing to fail, data to be lost, and sud-
den loud noises from monitoring equipment, which might
damage the equipment, harm hearing or cause other trouble.
1.
Press the SD card in gently to make it to come forward.
2.
Pull the SD card out by hand.

SD card write protection switches

SD cards have write-protection switches that prevent writing
new data to them.
If you slide the write-protection switch to the LOCK position,
dubbing will not be possible.
Remove write-protection to use the dubbing (copying) function.
TASCAM CD-400U DAB
21

Publicidad

Tabla de contenido
loading

Tabla de contenido