Assembly - goodbay 59513 Instrucciones De Uso

After each transport
• Place the air conditioner in an upright position�
• Allow the air conditioner to stand for at least 12 hours before operating it so that the refrigerant
can collect in the compressor� Otherwise, the compressor may be damaged!
6

Assembly

If you want to use the air conditioner in the operating modes cooling, dehumidification and automatic,
the exhaust hose (16) must be fitted in order for the exhaust air to be discharged from the room. No ex-
haust air is produced in the operating mode ventilation�
Proceed as follows to fit the exhaust air hose to the air conditioner:
1� Pull the exhaust hose (16) apart at both ends
Pay particular attention that the fins at the beginning and end of
the exhaust hose are fully unfolded.
2� Attach the hose adapter (15) to one end of the exhaust hose� To
do this, turn the hose adapter about 3 to 4 times counterclockwise
onto the exhaust hose�
The connection should be as airtight as possible.
3� Attach the adapter for the window insert (17) to the other end of
the exhaust hose� To do this, turn the adapter for the window in-
sert about 3 to 4 times counterclockwise onto the exhaust air
hose�
The connection should be as airtight as possible.
4� Attach the hose adapter to the air outlet for exhaust air (9) by pus-
hing the hose adapter into the frame from above�
The air conditioner is now assembled.
EN
28