Preparing For Use; Assembling The Device - Royal Catering RC-WC88 Manual De Instrucciones

A. Cooler interior lighting on/off button (press to turn on or off the light).
B. Temperature unit change button (press to change from degrees Celsius to degrees
Fahrenheit and vice versa; the selected temperature unit will be shown on the right side
of its value on the display)
C. Display of the current temperature inside the cooler and temperature unit display
D/E. The button for increasing/decreasing temperature within available range (press
the appropriate button to increase or decrease the temperature)

3.2. Preparing for use

APPLIANCE LOCATION
The ambient temperature should not exceed the range of 16-32°C (for the device
RC-WC428: 23
good ventilation in the room in which the device is being used. Keep a minimum
distance of approx. 10 cm from the rear and side walls of the device. The device
should always be used when positioned on an even, stable, clean, fireproof and dry
surface, and be out of the reach of children and persons with limited mental and
sensory functions. Position the device such that you always have access to the
power plug. The power cord connected to the appliance must be properly
grounded and correspond to the technical details on the product label. Level the
device using the adjustable feet. Before the first use, remove and wash all
accessories; wash the device inside and dry it thoroughly.

ASSEMBLING THE DEVICE

After transporting the device, do not turn it on for approx. 2 hours before connecting it
to the power source - the refrigerant must be evenly distributed around the system to
prevent possible failure of the cooling system as the result of the device being tilted
from the vertical axis beyond 45°.
3.3. Device use
1. After connecting the device to the power supply, it is necessary to set the
temperature using the adjustment buttons (D and E).
2. The cooling system will operate when the temperature inside the device is
higher than the temperature set on the controller. If the temperature inside
C -26 C), and the relative humidity should not exceed 85%. Ensure
o o