Cleaning And Maintenance - Royal Catering RC-WC88 Manual De Instrucciones

the device falls below the level set on the controller, the cooling system will
turn off and will remain disabled until the temperature rises above the control
level.
3. To turn on the interior lighting, press button A.
4. To change the temperature unit, press the button B.
5. The panel in RC-WC88 can be locked. This function prevents unwanted
changes in temperature settings. The lock function will be activated
automatically 12 seconds after the last button has been pressed on the control
panel. To unlock the control panel, press and hold the increase (D) and
decrease (E) buttons simultaneously for 3 seconds. The device beeps and the
panel flashes to indicate that the control panel is active, and the settings can
be changed.
PLEASE NOTE!
1. Grill shelves (trays) for beverage bottles are adapted to store standard wine
bottles, i.e. 0.75 L, and it is on this basis that the maximum number of stored
bottles has been calculated, although larger bottles can also be stored in the
cooler.
2. Adding several bottles at once will take more time to cool than when the
bottles are added individually.
3. Make sure that the cooler door is tightly closed and that nothing prevents it
from closing (e.g. insufficiently inserted shelf).
4. When first started, there may be an unpleasant smell inside the cooler. This is
normal and is not a defect of the device! Over time, the unpleasant smell
should disappear. The device takes time to cool the beverages to the right
temperature. Meanwhile, avoid opening the cooler door frequently and avoid
placing extra or new bottles in the refrigerator. The time to reach the set
temperature inside the device depends on ambient temperature, the initial
temperature of the beverage, its quantity, and the arrangement inside the
device. It may be extended if you turn the cooler on for the first time or if it
hasn't been used for a long time.

3.4. Cleaning and maintenance

a) Unplug the mains plug and allow the device to cool completely before each
cleaning, adjustment or replacement of accessories, or if the device is not
being used.
b) Use only non-corrosive cleaners to clean the surface.
c) Use only mild, food-safe detergents to wash the device.
d) After cleaning the device, all parts should be dried completely before using it
again.
e) Store the unit in a dry, cool place, free from moisture and direct exposure to
sunlight.