Menu Structure; Upgrading Your Gauge; Spares & Accessories - Elcometer 204 Guia Del Usuario

8 MENU STRUCTURE

Menu
Delete Last Reading
Calibration
Setup
About
Reset
Emergency Light
Display
Clear Statistics
Setup Display
Display Information

9 UPGRADING YOUR GAUGE

Gauge firmware can be upgraded to the latest version by the user via
®
ElcoMaster , as it becomes available. ElcoMaster will inform the user
of any updates when the gauge is connected to the PC with an
internet connection.
10 SPARES & ACCESSORIES
10.1 TRANSDUCERS
Each gauge is supplied complete with 5MHz 1/4" Potted Right Angle
Dual Element Transducer. Other transducers are available to order as
accessories - see Table 1 'Transducers' on page en-9.
Transducers are potted - the transducer cable is permanently fixed to
the transducer head - right angle, dual element, 'intelligent'
transducers. When connected, the transducer frequency and diameter
will be automatically identified by the gauge.
When choosing a transducer, the frequency, diameter and material
under test should be considered. As the Elcometer 204 is pre-
calibrated for steel, only transducers suitable for measuring on steel
should be used with this gauge.
Details of the transducer connected can be viewed at any time via
Menu/About/Transducer Information.
www.elcometer.com
All manuals and user guides at all-guides.com
Calibration
Zero Set
Setup
Units
Language
Beep Volume
Screen Settings
Gauge Auto Off
About
Gauge Information
Transducer Information
Contact
Legal
Setup Display
Top Display
Bottom Display
Units
○
mm
○
Inch
Screen Settings
Screen Brightness
Screen Timeout
○
Opening Screen
Legal
Legal Notices
Regulatory
Top Display
None
○
Statistics ○
Readings ○
Bottom Display
None
○
Statistics ○
Readings ○
®
R
Regulatory
en-8