Publicidad
Idiomas disponibles
Idiomas disponibles
5U106ebk3.book Page 5 Tuesday, April 15, 2003 1:22 PM
Install the ERA/O card in the system:
7
Unpack the ERA/O card.
a
If you are replacing an ERA/O card, see "Removing an ERA/O Card" for removal
instructions before continuing with the next step.
Position the ERA/O card so that the card connector is directly over the connector
b
on the system board and the mounting holes in the card line up with the support
posts on the system board. See Figure 1-4.
Press down until the ERA/O card connector is fully seated in the connector on the
c
system board and the support posts are secured in the mounting holes on the card.
F i g u r e 1 - 4 .
I n s t a l l i n g t h e E R A / O C a r d
ERA/O card
system board
ERA/O card
connector
All manuals and user guides at all-guides.com
Installing or Replacing an ERA/O Card
mounting
holes (4)
support posts (4)
1-5
Publicidad
