3. GUARANTEE
ZUMMO INNOVACIONES MECÁNICAS S.A., through its official distributor, guarantees their machines
for a period of 3 YEARS or 100.000 squeezing cycles, valid from the date of delivery to the distributor,
in accordance with the following conditions:
This guarantee covers all material or manufacturing defects.
If any faults are found during normal use and within the guarantee period, the defective parts will be
replaced free of charge.
Repair or replacement of machine parts during the guarantee period, does not imply and extension in
guarantee expiration.
The guarantee shall be valid only when presented with the original purchase invoice.
The original parts are covered by a six-month guarantee.
This guarantee does not cover
Any damages not directly caused by a fault of manufacturing or materials.
Any damages due to incorrect installation, abuse, improper use, modifications, accidents or negligence.
Any parts scratched due to use of improper washing.
Labour not covered by this guarantee.
Any damages caused by unauthorised staff or materials.
Any defects caused by use wearing down; in individual the following component:
•
0505016-1 PEEL EXTRACTING BANDS
•
1908014-1 MEDIUM CUP ELASTIC SUPPLEMENT (148mm)
•
1908015-1 LARGE CUP ELASTIC SUPPLEMENT (174mm)
Technical assistance
In case of damages caused during the guarantee period, we suggest you contact the Authorised Dealer
who supplied the unit, or call Zummo:
E-mail: sat@zummo.es
Tel: +34.961.301.246
Fax: +34.961.301.250
Any repairs not authorized by Zummo during the guarantee period will cause immediate termination of
the guarantee.
4. ACCESSORIES
The machine has various squeezing sets of Cups and Balls to use depending on the size of the fruit you
wish to squeeze.
a
Cup and ball in dark grey, for juicing fruit with a diameter of 63 to 75. If you need to squeeze
fruit with a diameter of 55 to 70, you need to fit the elastic accessory. (Fig. 13)
b
Optional. Cup and ball in light grey, for juicing fruit with a diameter of 75 to 90. If you need to
squeeze fruit with a diameter of 65 to 80, you need to fit the elastic accessory. (Fig. 14)
You must modify the classifier position to position Ø90. (Fig. 22B)
Regardless of the squeezing set use, the Blade will always be the same.
ATTENTION!: Never mix components of different sets.
22