Built-In Instructions - Dimplex V1525BT Manual Del Propietário

Fireplace Installation

Built-In Instructions

WARNINg: The installation
of the fireplace unit must
comply with the applicable
local and/or national electrical
codes and utility requirements.
This installation should be
entrusted to duly qualified
personnel where required by
law.
1. Leave the frame uninstalled
from the fireplace chassis
until step 13.
2. Prepare a wall opening fol-
lowing the dimensions shown
in Figure 5. note that 4" mini-
mum depth including thick-
ness of dry wall is required.
Make sure there is enough
clearance for the cable com-
ing out from the bottom of the
fireplace.
!
NOTE: Where there are
close tolerances involved in
wall building or applications
which require a great degree of
precision, we recommend that the
product itself be used to make
the actual measurements for the
wall opening. Dimplex north
America will not be responsible
for inaccuracies in the design or
manufacture of enclosures.
All manuals and user guides at all-guides.com
WARNINg: Ensure method of
installation does not obscure the
air intake slots on bottom of unit
in any manner. Keep minimum 4"
clearance from bottom of unit to
any surface such as the top of a
cabinet.
3. Wire a dedicated, prop-
erly fused circuit with 120V,
15amp rating. Allow up to 8
feet of service cable for con-
necting power supply to junc-
tion box on fireplace when
installing after finishing wall.
CAUTION:
use two conductor,
non-metallic sheath cable with
ground wire (3 wires total) for
the incoming power supply on
fireplace inserts. use appropriate
wire to meet local and national
electrical codes for rated power
consumption.
4. remove the outer jacket and
strip the individual conductor
from the end.
5. Loosen the screw securing
the junction box cover and
remove the cover.
6. Take the cables out from the
junction box, loosen the two
wire twist nuts and remove
the cord set. (Figure 6.)
7. Route the power supply wire
11