Maintenance; Light Bulb Replacement - Dimplex V1525BT Manual Del Propietário

Maintenance

WARNINg: Disconnect
power before attempting any
maintenance or cleaning to
reduce the risk of fire, electric
shock or damage to persons.
CAUTION: Turn unit off, allow
at least 5 minutes for light bulbs
to cool before touching bulbs to
avoid accidental burning of skin.

Light Bulb Replacement

Light bulbs need to be replaced
when you notice a dark section
of the flame or when the clarity
and detail of the log exterior
disappears. There are two bulbs,
which generate the flames and
embers.
Tool Requirements: Philips
screw driver
Helpful Hints: It is a good idea to
replace all light bulbs at one time
if they are close to the end of their
rated life. Group replacement will
reduce the number of times you
need to open the unit to replace
light bulbs.
Light Bulb Requirements:
Quantity of two 40W Chandelier
or candelabra bulbs with E-12
(small) socket base, 120 Volt.
DO NOT EXCEED 40 WATTS
PER BULB
16
All manuals and user guides at all-guides.com
Bulb Replacement Instructions:
1. Disconnect power supply
to the fireplace either by
unplugging the fireplace
or switch off at the breaker
panel.
2. remove fireplace front trim.
3. remove glass assembly.
remove the screws securing
the glass assembly on
the chassis. Hold on to
the handles on the glass
assembly with both hands
then lift the whole assembly
straight up to remove. Figure
11.
4. remove the two screws
securing the light block as
shown in Figure 12, then
remove the light block.
5. reach in and turn the burnt-
out bulb(s) counter-clockwise
to remove.
6. replace with new bulbs.
7. reassemble light block, glass
assembly and fireplace frame
in reverse order.
www.dimplex.com