Tabla de contenido
Publicidad
5
ATTACH THE AWNING: REAR POSITION.
For rear deployment, insert the nut plates at the rear of the Platform. Align them with the
brackets. TIP: Use the hex wrench to adjust the position of the nut plates as necessary. Using
the 5 mm hex wrench, secure each bracket with 2 thin washers and 2 screws. Before tightening
completely, be sure the awning is centered with the Platform and the set of brackets are
centered with the awning. Tighten the screws and the bolts to completely to 9 Nm ±1.
LOW POSITION
POSITION BASSE
POSICIÓN BAJA
HIGH POSITION
LOW POSITION
POSITION HAUTE
POSITION BASSE
POSICIÓN ALTA
POSICIÓN BAJA
ASSEMBLY - JETSTREAM LOW AND HIGH POSITION
1
INSERT THE BOLTS INTO THE AWNING TRACK.
With the awning on a stable surface, insert 2 bolts on each side into each of
the tracks. Slide the bolts toward the center (as shown in step 1 on page 2).
3
2
INSERT THE NUT PLATES.
REMOVE THE END CAP.
Pry up the weather-stripping to expose about 6
Press the tab at the bottom of
inches of the channel. Insert 2 nut plates into each
the end cap and pull to remove it.
crossbar. Press firmly to reinstall the end caps.
2X
Instruction #1036150A - page 4 of 11
Publicidad
Tabla de contenido
