Yakima 8004113 Instrucciones De Montaje página 5

4
ATTACH THE BRACKETS: CHOOSE LOW OR HIGH POSITION.
Using a tape measure, measure
the distance between your
crossbars. This measurement is
your M4. Place the brackets over
the bolts you inserted in step 1
being sure to orient the brackets
relative to the zipper as pictured.
Using a 13 mm wrench, install 2
thin washers and 2 nuts as shown.
Set the distance between the
center of the brackets to your
M4 measurement, and measure
to make sure the pair of brackets
are centered on the awning.
Tighten completely to 9 Nm ±1.
5
ATTACH THE BRACKETS.
Instruction #1036150A - page 5 of 11
=
Using a 5 mm hex wrench, attach the awning using 2 screws, 2
thin washers, and, 2 thick washers as shown for each bracket.
TIP: Use the hex wrench to adjust the position of the nut plates as
necessary to align with the screws. Tighten completely to 9 Nm ±1.
LOW POSITION
POSITION BASSE
POSICIÓN BAJA
zipper
glissière
M4
cremallera
LOW POSITION
POSITION BASSE
POSICIÓN BAJA
thin
thick
HIGH POSITION
POSITION HAUTE
POSICIÓN ALTA
=
HIGH POSITION
POSITION HAUTE
POSICIÓN ALTA
thick
thin
2X