SportDOG X Serie Manual De Funcionamiento página 12

SD-1825X-E
Your Remote Transmitter has 14 operational modes (seven with the toggle switch in the grey/a position and
seven with the toggle in the orange/b position) to allow you to select the best match for your type or style of
training. The Remote Transmitter is factory set to mode 5:a. There is also one programming mode (Mode V/T)
which allows you to change the system's ID code.
TO CHANGE THE MODE
1. Referring to the "SD-1825X-E MODE CHART" on page 13, choose your
desired mode number (1-7) and toggle position (a or b). Adjust both the
Intensity Dial and Toggle Switch to match your desired mode.
2. Turn the Remote Transmitter over and remove the belt clip (if attached).
3. Using a pen or the tine on the buckle of your collar strap, press and
release the Mode Button. When the Mode Button is pressed, the
Transmitter Indicator Light will be solid in colour. When it is released, it
will flash a number of times that corresponds to the mode selected.
For example, if mode 6:a is desired, switch the toggle to the grey/a
position and adjust the Intensity Dial to Level 6. Once the Mode Button has
been depressed, the Transmitter Indicator Light will be solid, and once the
Mode Button is released, the Transmitter Indicator Light will flash 6 times.
However, if you select Mode V/T (ID Code) in the grey/a position, the light
will remain solid in colour once the Mode Button is released.
*
Factory Default Mode.
For two-dog operation setup refer to STEP 07 on pages 14-15.
ƒ
^ For three- and six-dog operation setup refer to STEP 07 on page 14-15.
• Locate Remote Beeper: The Side Button turns run mode off and locates the
Remote Beeper. To enable run mode again, press and hold the Side Button
for 3 seconds.
12 WWW.SPORTDOG.COM
TOGGLE SWITCH IN
a
THE POSITION
TOGGLE SWITCH IN
b
THE POSITION