Match The Collar Receiver And Remote Transmitter; Program The System For Multi-Dog Operation - SportDOG X Serie Manual De Funcionamiento

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 77
b
7:
2
V/T
N/A
(ID CODE)
STEP :: 6 MATCH THE COLLAR RECEIVER AND
To match the Collar Receiver to work with a new Remote Transmitter or to reprogram a new Collar Receiver to
work with your existing Remote Transmitter:
1. Turn off the Collar Receiver.
2. Press and hold the On/Off Button. The Receiver Indicator Light will come on, then turn off after 4-5
seconds. If the On/Off Button is released too early, the Receiver Indicator Light will begin flashing as
normal. If this occurs, start again from Step 1.
3. After the Receiver Indicator Light has turned off, release the On/Off Button.
4. Press and hold the Upper Button on the Remote Transmitter until the Receiver Indicator Light flashes 5
times. Once the Receiver Indicator Light has flashed 5 times, the Collar Receiver has been matched and will
begin flashing as normal. If the Receiver Indicator Light does not flash 5 times, start again from Step 1.
STEP : 7 PROGRAM THE SYSTEM FOR MULTI-DOG
SD-425X-E, SD-825X-E, SD-1225X-E
SportDOG
Add-A-Dog
®
1. Program the Remote Transmitter to mode 3 or 4 (see TO CHANGE THE MODE on page 10).
2. Program the first Collar Receiver.
A. Turn off the Collar Receiver.
B. Press and hold the On/Off Button. The Receiver Indicator Light will come on, then turn off in
4-5 seconds. If the On/Off Button is released too early, the Receiver Indicator Light will begin its normal
flashing. If this occurs, start again and repeat from Step A.
C. After the Receiver Indicator Light has turned off, release the On/Off Button.
D. Press and hold the Upper Button on the Remote Transmitter until the Receiver Indicator Light flashes
5 times. If the Receiver Indicator Light does not flash 5 times, start again and repeat from Step A.
3. Program the second Collar Receiver by following Steps A through D above, but using the Lower Button in
place of the Upper Button.
4. Program the third Collar Receiver by following Steps A through D above, but using the Side Button in place
of the Upper Button.
14
Dog 1
Dog 2
Continuous
Stimulation
a
REMOTE TRANSMITTER
OPERATION
Collar Receiver(s) must be purchased to train two or three additional dogs.
®
High
Tone
N/A
WWW.SPORTDOG.COM
Vibe
Tone
N/A
See STEP 08
N/A

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Sd-425x-eSd-825x-eSd-1225x-eSd-1825x-e

Tabla de contenido