Table Of Pictograms Used Introduction; Intended Use; Residual Risk; Parts Description - Parkside PDWE 8 A1 Instrucciones De Funcionamiento Y De Seguridad

Table of pictograms used
Be Read the operating
instructions!
Note
Dispose of the pneumatic devices
and packaging environmentally
compatibly
138180
Air-driven maintenance unit
PDSP 8 A1
Introduction
Congratulations! You have purchased
one of our high-quality devices. Before
setup or first use, please familiarise
yourself with the product. To do so, please read
through the following operating and safety
instructions carefully. This tool must be set up or
used only by people who have been trained to do
so.
KEEP OUT OF THE REACH OF CHILDREN!

Intended use

z z
The air-driven maintenance unit serves to oil the
compressed air for pneumatic tools and at the
same time filters condensation from the compressed
air. Use the products only as described and only
for the specific applications as stated. Keep these
instructions in a safe place. Ensure you hand over
all documentation when passing the product on to
anyone else. Any use that differs to the intended
use as stated above is prohibited and potentially
dangerous. Damage or injury caused by misuse
or disregarding the above warning is not covered
by the warranty or any liability on the part of
the manufacturer. The device was designed for
household use and must not be used commercially
Table of pictograms used / Introduction
Observe warnings and the safety
instructions!
Wear hearing protection,
respirator / dust mask, goggles,
and protective gloves.
or industrially.

Residual risk

z z
Even if you operate the device according to the
instructions, there will always be residual risks
remaining. The following risks may occur in connec-
tion with the build and execution of this pneumatic
maintenance unit:
Danger from beating compressed air hoses.
„ z
Danger of falling from compressed air hoses
„ z
lying around.
Reduce the residual risk by carefully using the
device as intended and observing all instruction.

Parts description

z z
After unpacking the product, please check that
the device is in perfect condition. Do not use the
product if it is defective.
Filter unit
1
Compressed air controller
2
Compressed air pressure gauge
3
Condensate collection container
4
Filter insert
5
Drain valve
6
Oil mister unit
7
Screw to change the lubrication
8
Oil refilling inlet
9
Container for compressed air oil
10
Table of contents
GB/IE/NI 17