HQ-Power VDPLW1600 Manual Del Usuario página 3

4. Description
1. safety rope eyelet
2. LCD
3. encoder wheel
4. DMX output
5. DMX input
6. power supply
7. fuse holder
8. bracket
5. Installation
a) Fuse
• Only fit or replace a fuse when the device is unplugged from the mains.
• Replace a blown fuse with a fuse of the same type and rating (see "Technical Specifications"):
1. Remove the fuse holder under the power socket at the back of the device.
2. Remove the old fuse and install a new one.
3. Replace the fuse holder.
b) Mounting the Device
• Have the device installed by a qualified person, respecting EN 60598-2-17 and all other applicable norms.
• The carrying construction must be able to support 10 times the weight of the device for 1 hour without deforming.
• The installation must always be secured with a secondary attachment e.g. a safety cable.
• Never stand directly below the device when it is being mounted, removed or serviced. Have a qualified technician
check the device once a year and once before you bring it into service.
• Install the device in a location with few passers-by that is inaccessible to unauthorised persons.
• Overhead mounting requires extensive experience: calculating workload limits, determining the installation
material to be used... Have the material and the device itself checked regularly. Do not attempt to install the
device yourself if you lack these qualifications as improper installation may result in injuries.
• Adjust the desired inclination angle via the mounting bracket and tighten the bracket screws.
• Make sure there is no flammable material within a 0.5m radius of the device.
• Have a qualified electrician carry out the electric connection.
• Connect the device to the mains with the power plug. Do not connect it to a dimming pack.
• The installation has to be approved by an expert before the device is taken into service.
6. Operation
• Initialization
Initialization starts as soon as you connect your VDPLW1600 to the mains. After the initialization, the LCD will
display "Addr " when there is a DMX signal,
***
the projector will preset a non DMX running mode: auto, sound or manual.
• LCD Menu
Turn the jog wheel in a clockwise direction to display the following sequence:
Addr***, Manual Blue***, Manual Green***, Manual Red***, No DMX/Sound/Manual, Chase 8 s***f_**,
Chase 8 s***f_**, Chase 7 s***f_**, Chase 7 s***f_**, Chase 6 s***f_**, Chase 6 s***f_**, Chase 5 s***f_**,
Chase 5 s***f_**, Chase 4 s***f_**, Chase 4 s***f_**, Chase 3 s***f_**, Chase 3 s***f_**, Chase 2 s***f_**,
VDLPW1600
indicating the present DMX address. When there is no DMX signal,
***
3 HQPOWER