Qlima P 652 Instrucciones De Uso página 62

H
STORAGE
1.
2.
3.
4.
I
TROUBLE SHOOTING
Problem
Unit does not start
when pressing on/
of button
Not cool enough
Noisy
E0 Code
E1 Code
E2 Code
E3 Code
E4 Code
Never try to repair or dismantle the air conditioner yourself. Incompetent repairs
result in loss of warranty and can endanger the user.
4
62
Empty the internal water container.
Clean and replace the filter.
Put the unit in air circulation mode for 2 hours to ensure that the inside
becomes completely dry.
Protect the unit against dust and store it in a dry place.
Cause
Water full indicator lamp blinks,
and water tank is full
Room temperature is higher than
the setting temperature. (Electric
heating mode).
Room temperature is lower than
the setting temperature. (Cooling
mode)
The doors or windows are not
closed.
There are heat sources inside the
room.
Exhaust air hose is not connected
or blocked
Temperature setting is too high
Air inlet is blocked
The ground is not level or not flat
enough
The sound comes from the flow-
ing of the refrigerant inside the air
conditioner
Room temperature sensor failed
Condenser temperature sensor
failed
Water tank full when cooling
Evaporator temperature sensor
failed
Water tank full when heating
Solution
Dump the water out of the water
tank
Reset the temperature
Reset the temperature
Make sure all the windows and
doors are closed
Remove the heat sources if possible
Connect or clean the exhaust air
hose
Reset the temperature
Clean the air inlet
Place the unit on a flat, level
ground if possible
It is normal
Replace condenser
temperature sensor
Replace condenser temperature
sensor
Take off rubber stopper and empty
the water.
Replace evaporator temperature
sensor
Please empty the water tank