Startup And Commissioning; Pre-Startup Information - Tripp-Lite SRCOOLDXRW12 Manual De Instalación

6. Startup and Commissioning

6.1 Pre-Startup Information

Contact your service organization for official pre-startup checklist
Review the installation procedure and ensure all steps are completed properly. Ensure the room has proper vapor barrier in
place.
❏ q Visual safety inspection done ________________________________________
❏ q Service clearances (In-Row and condensers) checked __________________
❏ q Isolation valves installed (if specified by customer) ______________________
❏ q All accessories installed ___________________________
Review the electrical wiring and connections and ensure it is safe, done properly and compliant to code.
❏ q In-Row power is within range of nameplate ______V _____ Ph _____ Hz
❏ q Outdoor power input is within range of nameplate ______V _____ Ph _____ Hz
❏ q Circuit breaker/fuse sizes _______________________________________
❏ q Condenser control wiring connected _______________________
Check proper sizing and installation (including hangers and supports) of the refrigerant piping. Check for missing panels or
other items and ensure professional appearance for the customer.
❏ q Number of bends and traps recorded _________________________________
❏ q Condenser elevation (above In-Row Cooler) recorded ___________________________________
❏ q Piping diameters recorded ______________________________________
❏ q Pitching of horizontal lines ___________________________________
❏ q Piping clamps, cushioning and insulation present _________________________________
❏ q Long piping kit is present _________________________________
❏ q Condensate drain line routed properly _____________________________
19