Tabla de contenido
Publicidad
OPERATION
Use the high suction speed in cases of concentrated kitchen vapours. It is recommended that the
cooker hood suction is switched on for 5 minutes prior to cooking and to leave in operation during
cooking and for another 15 minutes approximately after terminating cooking.
To select the functions of the hood, simply touch the controls.
T1.
Standby mode (the control panel of all functions disabled) / ON (control panel switched on)
Note: After about a minute of inactivity (suction and lights), the hood will automatically switch to
standby.
T2. ON/OFF lights
On certain models only (see drawing above):
press repeatedly to select the desired light intensity:
L1: low light
L2: medium light
L3: high light
Press again to turn of the lights.
T3. ON/OFF Automatic operation "AdaptTech".
The hood automatically sets the suction speed (power) 1 to increase if the environmental condi-
tions detected by the hood sensor require it.
If there are no variations in the environmental conditions, after 10 minutes (if the hood is already
in suction speed (power) 1), the hood turns of.
Note: for a correct use of this function, irst perform the "Setting of the parameters for Automatic
Operation" (see corresponding paragraph).
Note: During automatic operation, if the user acts on the other functions that adjust the speed,
auto ventilation function is switched of.
T4.
Manual selection of the suction speed (power):
L4: suction speed (power) 1
L5: suction speed (power) 2
L6: suction speed (power) 3
Press again to turn of the hood (OFF).
Note: manual selection excludes any other suction related set function.
T5. ON/OFF Intensive suction speed (power) „POWER BOOST" (timed)
Note: After 5 minutes of operation the hood returns to its previous state.
T6*. (Only certain models ON/OFF intensive suction speed (power) „POWER BOOST x 2" (timed)
Note: After 5 minutes of operation, the hood goes back to the previous status.
T7.
ON/OFF operation mode "Refresh".
Every 50 minutes of inactivity, the suction speed (power 1 is turned on for 10 minutes.
T8. ON/OFF Delayed switch of of the suction speed (power) (approx. 30 minutes
Note: this function is available for the speeds that can be selected with button T4.
T9. Indicator and reset ilter saturation
The button lights on automatically with steady light when it is necessary to perform the grease
ilter maintenance. The button lights on automatically with lashing light when it is necessary to
perform the charcoal ilter maintenance.
After performing the maintenance, with the hood of and the button active, press the button for
more than 3 seconds to perform the reset of the ilter saturation indicator; repeat the operation if
necessary (for ex., when both ilters are saturated).
Activation of the charcoal ilter saturation indicator
The saturation indicator of the charcoal ilter is normally disabled. To activate it, proceed in the
EN 32
Publicidad
Tabla de contenido
