Clarke RA40 Instrucciones De Uso página 17

4. Adjust the solution flow by pressing the push-button (44) as necessary, depending on the type of cleaning to be performed.
NOTE
For the first 3 flow levels (Fig. 4), the amount of solution dispensed is automatically adjusted according to the machine
speed, in order to obtain a constant amount of solution per linear meter of cleaning.
Level 4 (when enabled) supplies the maximum possible quantity of detergent solution, regardless of the machine speed
(to enable or disable this, see the Super User key section in the Maintenance chapter).
The level 0 closes the solution flow completely.
Lev.
1
0,75 cl/m
NOTE
All of the above solution flow values are factory settings.
To change these settings, see the operating parameters paragraph in the Maintenance chapter.
NOTE
For correct scrubbing/drying of floors at the sides of the walls, Clarke suggests to go near the walls with the right side of
the machine as shown in figure 5.
A
5. To stop scrubbing/drying, press the push-button (42) and wait for the brush deck (7) to lift. After 10 seconds, the vacuum
system turns off too and the squeegee (13) lifts.
01/2015
Lev.
3
Lev.
2
1,5 cl/m 3,0 cl/m
Figure 4
Figure 5
INSTRUCTIONS FOR USE
Lev.
4
Lev.
0
2,8 l/min
B
9100000394 - RA40
ENGLISH
OFF
P100866
P100867
15