Rig Bar/Panel Assembly; Bottom View - Chauvet Professional F4 Manual Del Usuario

Mounting
Rig Bar/Panel
Assembly
Rig Bar Speego
Tightening
Spring
Knob
Knob
Locking Bar
10
Alignment Conical
(x2)
Rig Bar Locking Latch
1. Insert alignment conicals into the alignment holes and allow magnets to connect.
2. Insert the Rig Bar Speego locking bars into the female Speego connections on the F4.
3. Twist the spring knob on the Rig Bar Speego by 90°, until it locks into place.
4. Twist the tightening knob clockwise until F4 is secure to Rig Bar.
5. To detach the Rig Bar from the F4, reverse the previous steps.
·
The alignment magnets on the F4 and F-Series Rig Bar are designed to
temporarily hold the weight of the panel to allow the user to properly align and
tighten the panel into place.
·
Either side of the F4 with female Speego connections can attach to the F-Series
Rig Bar, but only the short side has alignment conicals and magnets. When
attaching the long side of the F4 to the Rig Bar, take care to ensure that the
pixels across the video assembly are aligned properly.
Warning! The magnetic attachments are not load-bearing, and are intended for
alignment assistance only. Do not release panel until the hanging hardware has
been fully secured.
Alignment Magnets
Alignment Holes
Male Speego Connection

Bottom View

Top View
Rig Bar Locking Tab
F4 User Manual, Rev. 2