Connecting (Cabling) Each F4; Testing Signal And Power Connections; Using The F4 Test Button - Chauvet Professional F4 Manual Del Usuario

Connecting (Cabling) Each F4

6. Connecting (Cabling) Each F4
Testing Signal and
Power Connections
Rear Panel View
Using the F4 Test
button
16
Each F4 has 2 power sockets and 2 signal ports.
· The Power and Signal connections are located on the underside of the service
module of each panel.
· The Signal ports may be used interchangeably.
· Each F4 has LED indicator lights on the test button in the center of the panel.
· Each panel indicates a successful power connection when the Power indicator light
remains red.
· Each panel indicates the presence of a signal when the Signal LED indicator light
blinks green quickly. When the LED blinks green slowly, there is no signal.
Test Button/
Power/Signal Indicator LEDs
Each F4 also has a Test button, used to ensure all LEDs are functional. Use the Test
button on each panel to perform a self-test. If self-testing, you must perform the test
individually for each F4. You do not need to connect to a signal or use software.
When using the Test button, make sure the F4 is NOT connected to the VIP Drive
43Nova.
To use the Test button, you must connect the power, but do not connect the signal
cables. Press the Test button to toggle through various LED light display configurations.
Underside of Service Access View
Signal Connections
Power In/Out
F4 User Manual, Rev. 2