7. LED Module Care and Replacement
F4 LED Module
LED Lot Numbers
Using MT-03
F4 User Manual, Rev. 2
Each F4 has 4 LED modules connected to the panel frame by magnets. Each module
has a single connector that connects to the main processing unit.
To ensure consistant color matching and output, replace damaged or defective modules
with the same LED lot # as the others on the panel. When combining panels to create
full video wall systems (rentals, permanent installations, etc.) it is highly recommended
that the LED lot #'s on each of the panels match. LED lot #'s can be located on the back
of each module.
Connector
Squeeze to attach
magnets to module
Magnet (x2)
The MT-03 is specially designed to carefully remove and replace the F4 LED module
from the front while the panel is mounted in a video wall setup. Before using this tool, be
sure to familiarize yourself with how this tool works by reading all the module
removal/installation procedures.
LED Module Care and Replacement
Steel Plate
(x2)
LED LOT #
Slide latch to release/
retract magnets
Roll to remove
from module
19