Joie i-Gemm 3 Manual De Instrucciones página 6

Installation with base
ISOFIX Installation see images
1. Unfold the load leg from storage compartment.
2. Fit the ISOFIX guides with the ISOFIX anchor points.
guides can protect the surface of the vehicle seat from being torn.
They can also guide the ISOFIX connectors.
3. Rotate the ISOFIX connectors 180 degrees until they are pointing in
the direction of the ISOFIX guides.
4. Line up the ISOFIX connectors with the ISOFIX guides, and then
click both ISOFIX connectors into the ISOFIX anchor points.
!
Make sure that both ISOFIX connectors are securely attached to
their ISOFIX anchor points. There should be two audible clicks and
the colors of the indicators on the both ISOFIX connectors should be
-1
completely green.
4
!
Check to make sure the base is securely installed by pulling on the
both ISOFIX connectors.
5. After placing the base on the vehicle seat, extend the load leg to
floor , When the load leg indicator shows green means it is
5
installed correctly, red means it is installed incorrectly.
!
The load leg has 24 positions. When the load leg indicator shows red
this means the load leg is in the wrong position.
!
Make sure the load leg is in full contact with the vehicle floor pan.
!
Squeeze the load leg releasing button, then shorten the load leg
upwards.
The completely assembled base is shown as
!
The ISOFIX connectors must be attached and locked onto the
-1
ISOFIX anchor points.
6
!
The load leg must be installed correctly with green indicator.
5
-
1 11
1
The ISOFIX
2
3
4
-3
5
6
-2
6
6. Push the infant carrier module down into the base
enhanced infant child restraint is secure, the enhanced infant child
restraint indicator shows green.
!
Pull up on the infant carrier module to be sure it is securely latched
into the base.
7. To release the infant carrier, pull the infant carrier up
squeezing the infant carrier release button.
8. To remove the base, press the secondary lock button
-2
then the button on the ISOFIX connectors before removing the
10
base from the vehicle seat.
9. Press the ISOFIX releasing button to fold the ISOFIX.
Vehicle Belts Installation see images
1. Unfold the load leg from storage compartment.
2. After placing the base on the vehicle seat, extend the load leg to
floor , When the load leg indicator shows green means it is
5
installed correctly, red means it is installed incorrectly.
!
The load leg has 24 positions. When the load leg indicator shows
red this means the load leg is in the wrong position.
!
Make sure the load leg is in full contact with the vehicle floor pan.
!
Squeeze the load leg releasing button, then shorten the load leg
upwards.
3. Open the lock-off and route the vehicle safety belt through the belt
-1
path , and lock it into the buckle.
12
4. Tighten the vehicle safety belt as much as possible while pushing
down on the base, and check it is not loose or twisted, then close
-3
the lock-off.
12
!
The infant child restraint can not be used if the vehicle safety belt
with female buckle is too long to tie the base.
, if the
7
8
-2
9
-1
9
-1
10
10
11
-
12 16
1
5
-2
12
-4
12
while
first and
-3
6