DeWalt DW746 Manual De Instrucciones página 6

Hardware Included with the DW746 Woodworker's Table Saw
Bolt
10 mm x 35 mm
(2 pieces)
Bolt
10 mm x 25 mm
(8 pieces)
Carriage Bolt
8 mm x 20 mm
(4 pieces)
FLAT WASHER
(14 PIECES)
10 MM LOCK WASHER
(14 PIECES)
PARTS SHOWN ARE FULL SIZE - EXTRA FASTENERS MAY HAVE BEEN INCLUDED
All manuals and user guides at all-guides.com
T50 Torx
Flat Head Screw
10 mm x 30 mm
(4 pieces)
M 10 NUT 16 MM HEX
(8 PIECES)
M 8 NUT 13 MM HEX
(4 PIECES)
8 MM LOCK WASHER
(4 PIECES)
WRENCH
HOOK
(1)
3
• 10 mm open end wrench
• T20 and T25 Torx drivers
• T40 Torx wrench.
Your will also need:
• Mild solvent cleaner such as mineral spirits, paint
thinner or denatured alcohol.
• High quality paste wax
Necessary Hardware
Your hardware bag, located in the parts box, contains all
the necessary nuts, bolts and washers to assemble the
components included with the DW746 Woodworker's Table
Saw.
5 MM
To make assembly of your saw easier, match the nuts,
HEX
WRENCH bolts and washers with the chart on the next page.
( 1 )
Separate them by size so that you can easily locate the
item you need. Before each step, check your hardware
against the chart and identify the pieces you need.
FIG. 1
Assembly for DW746
PLEASE READ ENTIRE ASSEMBLY
STEP 1. Remove parts box, motor cover,
fence beam and side tables from saw.
STEP 2. Turn the saw right side up. You will
need help. The combined weight of the
table top and motor assembly is
approximately 200 lbs.
STEP 3. Cut and remove plastic strap holding the motor.
STEP 4. Using front hand crank, lower the motor some
and remove the foam packing material between the
motor and the mechanism.
STEP 5. Install bevel crank. (Fig. 1) To do this, first install
T50
the crank handle (A) over the shaft (B), rotate it slightly
TORX
to fully engage the shaft pin. Screw the lock knob (C)
WRENCH
(1)
FIG. 2
A
B
C
SECTION
BEFORE PROCEEDING.