ARIETE 1312 Manual De Instrucciones página 36

Press the button of the previously selected beverage to start coffee brewing.
The appliance automatically stops brewing coffee when the default or the previously selected size is reached.
To stop brewing before the process is over, press the "Stop" button.
To make the rst coffee at the proper hot temperature, fasten the lter holder to its seat keeping the lter
installed (without introducing ground coffee). Distribute cup of coffee so that hot water can clean and heat
up the lter. This will not be necessary for the following coffees.
NOTE
Warning!
Slowly turn the lter holder from right to left to remove it so as to avoid splashing water or coffee.
Remove the lter holder (Fig.
Remove the lter from the lter holder by means of the handle of a teaspoon: lift the edge of the lter to remove it.
How to make froth for milk-based beverages
Make coffee as previously described.
B
Warning!
Danger of burns. Only touch the steam/hot water wand on the rubber part.
Pour milk to be frothed into the milk container.
3 Place the steam/hot water wand into the milk container (Fig.
Press the milk container button in the "Froth Amount" page to start froth distribution according to the previ-
ously con gured settings.
When warming up, your appliance may release small puffs of steam from the lter holder this is perfectly
normal.
A
36
A
.
).
).
The appliance automatically stops frothing milk when
the default or the previously selected amount is
reached.
To stop brewing before the process is over, press the
"Stop" button.
First a small quantity of water will come out, then a
strong steam jet. Deeply introduce the steam/hot wa-
ter wand into milk. In a few minutes a thick and creamy
froth will appear, which you can pour on the coffee
made before to complete preparation of the selected
beverage.
.
.