Tabla de contenido
Publicidad
Compliance
Product Specifications
Cellular Communication Module power supply: 24 VAC
from host ICC2 Controller
Cellular connection: LTE-M (Cat-M1); NB-IoT
Cellular modem carrier approvals:
• AT&T End-Device Certified (LTE-M)
• Verizon End-Device Certified (LTE-M)
• Bell End-Device Certified (LTE-M)
• Telus End-Device Certified (LTE-M)
• Compatible with other carriers offering LTE-M/NB-IoT
services
Cellular bands supported:
• 1, 2, 3, 4, 5, 8, 12, 13, 18, 19, 20, 25, 26, 28, and 39
Compliance
FCC:
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference
received, including interference that may
cause undesired operation.
This equipment has been tested and found to comply
with the limits for a Class B digital device pursuant to
Part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful
interference in a residential installation. This equipment
generates, uses, and can radiate radio frequency energy
and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio
communications. However, there is no guarantee that
interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio
or television reception, which can be determined by
turning the equipment off and on, the user is encouraged
to try to correct the interference by one or more of the
following measures:
22
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment
and receiver.
• Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV
technician for help.
Changes or modifications not expressly approved by
Hunter Industries could void the user's authority to
operate this device. If necessary, consult a representative
of Hunter Industries Inc. or an experienced radio/
television technician for additional suggestions.
To satisfy FCC and ISED RF Exposure requirements for
mobile and base station transmission devices, a separation
distance of 10" (25 cm) or more should be maintained
between the antenna of this device and persons during
operation. To ensure compliance, operation at closer than
this distance is not recommended. The antenna(s) used
for this transmitter must not be co-located or operating in
conjunction with any other antenna or transmitter.
Publicidad
Tabla de contenido
