LUND 67526 Manual De Instrucciones página 8

GB
APPLIANCE CHARACTERISTICS
The electric grill is an appliance designed for heating, cooking and preparing dishes requiring heat processing. The appliance is
not intended for commercial use. Proper, reliable and safe operation of the appliance depends on appropriate use, that is why
you should
Read and keep the entire manual before the fi rst use of the appliance.
The supplier shall not be held liable for any damage or injury resulting from improper use of the appliance or failure to observe
the safety regulations and recommendations of this manual. Use of the appliance for purposes other than those for which it was
intended shall cause the loss of the user's rights to the guarantee and also under warranty.
ACCESSORIES
The appliance is supplied complete and does not require assembly. However, before using the appliance, remove all packaging
and transport protection elements. Preparatory activities described later in this manual are also required.
GENERAL INSTRUCTIONS FOR USE
The appliance has been designed for home use and is not allowed to be used in commercial applications, e.g. in catering facilities.
The appliance is intended for indoor use only. Do not expose the appliance to rain or other precipitation.
The appliance can be used only for heat processing of food placed directly on the cooktop. It is forbidden to use the appliance in
any other way, for example as a heater for the products inside a dish.
It is forbidden to repair, disassemble or modify the appliance on one's own. All repairs to the appliance must be carried out by an
authorised service centre.
The appliance must be kept under supervision at all times during operation.
WARNING! During operation, the appliance heats up to high temperature, do not touch the cooktop and the walls of the appliance
during operation, as this may cause severe burns.
The appliance is not intended for use by children under at least 8 years of age and by persons with reduced physical and/or mental
abilities and by persons without experience in or understanding of the operation of the appliance. Unless they will be supervised or
instructed to use the appliance safely, in a manner ensuring that the risks involved are understood. Children should not play with
the appliance. Unattended children should not be allowed to perform the cleaning and maintenance of the appliance.
Recommendations concerning transport and installation of the appliance
The appliance may only be placed on a hard, fl at, level and non-fl ammable surface. The surface should be able to withstand the
weight of the appliance itself and of the food placed on it.
Ensure that there is a minimum distance of 10 cm around the side walls of the appliance, and do not place non-high temperature
resistant materials above the appliance. This will allow for the proper ventilation of the appliance. Do not place near edges of, e.g.,
a table. Do not place the appliance near fl ammable materials, e.g. curtains or drapes.
Do not place any electrical equipment above the appliance. During operation, water vapour is released, which can cause a short
circuit in the electrical system and lead to electric shock.
It is forbidden to drill any holes in the product, as well as making any other modifi cations of the appliance not described in the
manual.
Move the appliance only when cooled, grasping the housing. Do not move the appliance by pulling on the power cord.
The temperature at the place of installation and use of the appliance must be within the range of +10 C ÷ +38 C, and the relative
O O
humidity must be below 90% without condensation.
Recommendations for connecting the appliance to the power supply
Before connecting the appliance to the power supply, make sure that the voltage, frequency and performance of the power supply
corresponds to the values shown on the appliance's rating plate. The plug must fi t into the outlet. It is forbidden to modify the plug
in any way.
The appliance must be connected directly to a single power supply socket. It is forbidden to use extension cords, adapters or
double sockets. The power supply circuit must be fi tted with a protective conductor and at least a 16 A protective device.
Avoid contact of the power cord with sharp edges, hot objects or surfaces. During operation, the power cord must always be fully
extended and the position of the power cord must be set so that it does not become an obstacle during operation. The power cord
shall not be placed a manner that would pose a risk of tripping. The power supply socket should be located in a place where it is
always possible to quickly remove the appliance power cord plug. Always pull the power cord by the plug housing when unplug-
ging it, never by the cord.
If the power cord or the plug are damaged, immediately disconnect it from the power supply and contact an authorised service
centre of the manufacturer for replacement. Do not use the appliance with a damaged power cord or plug. The power cord or plug
cannot be repaired and must be replaced with a new one that is free of defects if these components are damaged. Replacement
O R I G I N A L I N S T R U C T I O N S
8